Email adress (required)
Serial number (required)
Username or e-mail *
Lost your password?
Don't have account?Register
E-mail address *
Dimafix is a spray adhesive for use with 3d Graften printers at ABS.
In stock (can be backordered)
There are no reviews yet.
You must be logged in to post a review.
Temperature sensor for a 3D printer – 100K thermistor with 90 cm cables. Can be used to measure the temperature of the table and the head.
Bipolar, four-wire stepper motor. It has a resolution of 400 steps per revolution (0.9 degrees). Powered by 3.0 V, it consumes 1680 mA for the coil. The torque is 4.4 kg * cm (0.45 Nm). Dimensions are 42 x 42 x 48 mm (NEMA 17).
Imię i nazwisko (wymagane)
Adres email (wymagane)
You can specify the conditions for storage or access in your browser.