– with one print head to provide maximum working area: 200/180 / 200mm,
– with two heads, which mainly enable the use of a variety of support materials (eg water-soluble), but for some more advanced users there is a possibility of? Multicolor prints. The maximum workspace in this configuration is slightly smaller, but it nevertheless surpasses the average 3D print size of the statistical user.
Using small diameter nozzles makes it easy to obtain high quality and precision prints of up to 60 microns (with 0.2 mm nozzles), while swapping them up can significantly reduce print time.
Dimafix provides excellent adhesion between print and glass so that peeling off prints is not a problem, even with large ABS prints. You can print from a variety of thermoplastic materials: ABS, PVA, Filaflex, Polypropylene, HIPS, Adhesion to the substrate is activated when the table temperature reaches more than 50 ° C.
Gdy temperatura stołu spada (40-50ºC) efekt klejenia znika i modele łatwo odchodzą.
Jest rozpuszczalny więc jest łatwy do czyszczenia wyłącznie wodą.
Opakowanie Dimafix 400ml starcza na ponad 100 wydruków.